Ok, in this article I will show you how to install a ceiling vibrator quickly. You can install it in 5 minutes maximum. Are you ready? Start timing.
1. Test the vibrator to see if it works properly
Note: Here please place the vibrator with the flat surface facing upwards as shown in the picture. If it is placed diagonally or upside down, it will not work properly.
2. Measure the distance from the floor to the ceiling.
Either with a ruler or with the distance measuring function that comes with the iPhone.
3. Assembling the support rods by comparing the distance from the floor to the roof with the length of the support rods
Stand the combination support rod up and place it diagonally to see if the top is already close to the ceiling.
If so, the short support rod is not needed. If not, the short support rod needs to be assembled.
4. Adjust the knob of the adjustable base to the bottom
Assemble the adjustable base to the bottom end of the combination support rod.
5. Assembly of the vibrator to the top of the combined support rod
Ensure that the combination support rod is vertical and keep adjusting the knob of the adjustable base upwards until the vibrator rests firmly against the ceiling.
Observe whether the ceiling vibrator system is vertical. If not, manually fine-tune it to vertical.
Tighten the knob of the adjustable base.
6. Connect the power, turn on the ceiling vibrator and enjoy
Ceiling Vibrator Installation Tips
- The adjustable base must be placed on a hard object, that must be hard, strong, and horizontal. Must not soft cushion, if placed on a soft cushion, with the violent vibration of the vibrator, the whole ceiling vibrator system is very easy to dump. It is recommended to place the adjustable base directly on the floor of your apartment.
- There will be a slight wobble at the interface between the support rods, do not worry, this is a normal phenomenon. If made with very tight articulation, then with violent vibration, the support rod articulation will be severely deformed and will soon become unable to perform its function.
- After installation, observe it for 30 minutes, if the support rod will tilt or collapse, it means it is not installed properly, please re-adjust the position and install it.